CARPRO CQUARTZ Leather 2.0 leather and vinyl coating, 50 ml

CARPRO CQUARTZ Leather 2.0 — 50 ml kit

Water-based protective coating for vehicle leather and vinyl, including Nappa leather. CARPRO describes hydrophobic, self-cleaning protection against UV, denim dye transfer, abrasion and stains while preserving colour. Kit: one 50 ml bottle, applicator block and two hologram stickers.

Prepare and apply

1. Work at 15–30°C and test an inconspicuous area. Clean with a product that leaves no sealant or dressing; wipe residue with a damp towel if needed and dry fully.
2. Contents are under pressure. Do not shake. Open slowly, wearing gloves, and aim away from people.
3. Draw a line of coating onto the sponge side of the applicator block. Work into the leather, including pores and creases.
4. Gently wipe excess within 2–3 minutes.

Drying and aftercare

Dry for 1 hour at 25°C or 2 hours at 15°C; CARPRO strongly advises using a fan. A second layer may be applied after 30 minutes with a fan, 1 hour at 25°C or 2 hours at 15°C. Touch-dry: 4 hours; full drying: 12 hours. Do not clean the leather during the first 3 days.

Safety

The CARPRO Leather 2.0 safety data sheet in the attached manual (UFI TS10-Y05U-900D-XD9C) classifies it as skin irritant (H315) and causing serious eye damage (H318); signal word: Danger. Wear protective gloves/clothing and eye/face protection. If in eyes, rinse cautiously for several minutes, remove contact lenses if easy and continue rinsing; immediately contact a poison centre or doctor. Keep out of reach of children.